Configuring Sepura mobile radio
To bridge SDS messages, status messages and location data from Sepura radio to TASSTA network, configure radio's PEI interface.
Enable SDS and status messages
- Start Sepura Radio Manager.
- Go to Templates -> PEI Parameters -> General PEI Parameters.
- Change the setting for:
- CC Data: select Route to PEI1;
- SDS Status: select Route to Both;
- SDS-TL: select Route to Both.
Enable location data
- Start Sepura Radio Manager.
- Go to Templates -> Accessory -> GPS.
- Change the setting for:
- Default GPS Report Type: select ETSI LIP.
- Default GPS Report Interval [sec]: specify the interval in which the radio updates its location. For example, every minute (0:01:00).
- Default GPS Report Distance Km: specify the distance traveled, after which the radio will update its location. For example, every 500 meters (0.5).
- Send GPS in DMO: select None.
- Destination Identity: specify SSI of the Sepura radio connected to T.Bridge.
Note: |
The new location data is reported either after the specified time interval or after traveling the specified distance, whichever happens first. |